40
Values beneath addresses are default programming.
1
Auto Bypass is applicable to Instant (Non-Delayed or Non-Follower) zones only.
Address
- a location on the programming sheet.
Addresses reside between 010 and 380.
Value
- determines the characteristics of an address.
2.2
Introduction
The program determines most of the control panel features. Programming is performed in order
to enable maximum compatibility of the control panel with the specific site.
The control panel is supplied with the basic ‘Factory Default Program,’ which is in effect at system
power up. (See also: Factory defaults programming.)
Before starting programming, it is advised to mark the desired values on the programming sheet.
2.3
Programming Sheet Explanation
Table
:
Addresses 010 to 013 are used to enter the telephone numbers that will be dialed upon alarm
or at other events (when communicator to central station has been programmed).
Telephone numbers 2 & 3 are for communicator (if selected), or non-communicator, according to
programming of addresses 201 & 202. Telephone numbers 1 & 4 are only for regular telephone dialer
with alarm sound.
Table
:
Enter the zone feature by zone number, as described in addresses 019 to 041.
Addresses 050 and 051 manage five different features, which specify the alarm outputs upon Panic
and Tamper alarm.
Note:
Entering a ‘0’ value in an address will delete all 4-alarm outputs during Panic or Tamper alarm at
that address zone.
Table
: Addresses 059 to 069 indicate siren, delay and other time out. Enter the time in two digits (e.g.
for 2 seconds, enter 0 and then 2).
Table
:
Addresses 070 to 074 indicate special features of the system. Enter the required features by
their number in each address. Each address have eight different parameters. For AUSTEL approved
systems enter the value ‘8’ in address 074.
Table
: Addresses 080 to 091 indicate telephone and modem specifications according to local
telephone company requirements.
Table
: Address 099 provides setting of user codes 1 to 8 within the programming mode.
Table
:
Address 200 reverts system to Factory Default: AV-868/2008 by entering 80, AV-865/2005 by
entering 55.
