50
For example: User 2 is not to be reported for Closing: Program 00 in address 222; or, user 3 is not to be
reporting for Opening; program 00 at address 242.
If you check the contents of address 242 (00 is programmed), a '-' will be displayed, indicating that this
location is blank (empty).
Starting with version 1.04, subscriber ID codes can be entered as a sequence of four digits for faster and
easier programming; refer to addresses 360 to 376. For special applications, you may also enter the ID's
address by address (refer address 260 to 283).
Communicator’s Subscriber ID Codes - EASY Programming
Refer to programming table, part 10; System is in program mode, enter ID address, 4 LEDs are blinking,
enter the subscriber ID code in sequence.
Example: Your subscriber ID number is 2170 for Closing/Opening of telephone 1; refer to address
number 376. Keypad in programming mode, ‘P’ is displayed, press 376, 4 LEDs are blinking, enter
2170.
Note: Even if your communicator receiver requires three digits for the subscriber ID, enter 4
digits. The system will ignore the fourth digit automatically
If your central station requires programming of letters as well as numbers, please refer to the HEX
programming description. Use the regular programming method of entering each letter or number in
each address, as explained in the programming table (HEX method).
Note
:
EASY Programming is not included in the
EasyLoad
screen (programming via computer).
Contact ID Format (known also as Ademco Express):
This is the fastest to program and easiest to
use communicator format, with communication speed achieved by the DTMF signaling. When using
this format, program only Central Station (CS) telephone numbers and the subscriber ID; all reports will
be automatically transmitted, with no need to program anything else.
2.8
Reset System to Default Programming
In case you made programming changes and the system operation is wrong it’s recommended to set
system to the defaults program.
Warning!
This function erases all codes and system settings.
1. Enter program mode.
2. AV-2008: Go to address 200 and enter ‘8’ and ‘0.’, or ‘8’ and ‘8’ for AV-2008D. AV-2005: Go to
address 200 and enter ‘5’ and ‘0.’
Display will show system type, version and version date. For example AV-865 version 2.09 display:
5r 209 d 01 04 99
. System will revert to factory default program and codes; master code is 1 2 3
4, programming code restore to 1 9 9 4.
