34
SECTION IV: PROGRAMMING
1. SYSTEM CODES
Up to eight different Arming/Disarming codes and one installer (dealer) code are available; each code
consists of 1 to 6 digits.
Do not use ‘0’ as the first digit in a code.
Do not use ‘5’ as first digit in a code number if
Instant Arming via key 5
is programmed.
User code must not start with the same numbers as the installer programming code (1994).
Do not use same codes or same first digit for different codes. For example if code No. 1 is 1234, do not
program code No. 2 to be 1256.
1.
Default Arming and Disarming Code ‘1 2 3 4’
(Code No. 1) - Use ‘1234’ as Arming Code (also
called Owner Code). Use code No. 1 to program a new user code.
Upon setting new Arming & Disarming code, default user code ‘1234’ is automatically replaced. For
setting default codes
, Power up by applying AC and battery and immediately hold-down keys
*
#
Press both
together
after 2
nd
beep, release keys. ‘U’ will be displayed 3 times in confirmation.
2.
Code number 7 for access control
(requires programming) - Arm/Disarm code No. 7 activates
SLO (Selective Output), which is used for such functions as opening an electric lock.
Code number ‘7’ is operative during both, ARM and DISARM modes, confirmed by 7 short beeps.
Code 7 drives the SLO output as ‘Momentary’ output.
Pulse duration is 5 seconds.
3.
Code number 8 as Visitor
Code
(requires programming) - Arm/Disarm code No. 8 may be
programmed as a ‘one time code’ (employees and one-time visitors). This code is valid for 30 seconds
from Arming. After 30 seconds, the code is rendered invalid. Entering code 8 will delete zone bypasses,
including auto-bypass.
4.
Code number 9,
Programming Code (Installer Code)
- Code No. 9 enables entering the
programming mode (system features programming) at the Installer level.
The factory default programming code is ‘1 9 9 4.’
The programming code may be installer-programmed. Installer code does not Arm or Disarm system.
5.
User Codes
- (Arming/Disarming code). Each code consists of 1 to 6 digits. System provides
eight user programmable codes.
6.
Key Visual Feedback -
Visual ‘feedback’ from the keypad display upon entering of code. This
feature indicates the code entry progress and is most practical when the keypad sounder is disabled at
Group Bypass mode, or if selected by programming. Entry of code by user or installer is confirmed at
keypad display. Display segments will light up clockwise, indicating the sequence of the digits entered.
7.
Code Error
- The keypad is locked after six unsuccessful trials to enter a valid code.
Typing six erroneous codes locks the keypad keys for 30 seconds
