31
Arming of System with Instant or
24H troubled zones
Five warning beeps + troubled zone display
Feature programming
Two confirmation beeps
Follow-Me number programming
Two confirmation beeps
During alarm (requires programming)
Intermittent beep until alarm reset
1.5
LED Indicators
Four keypad LEDs provide visual indication of System status, as well as confirmation of various
modes.
Red ARMED/ALARM Indicator
- Lights up when system is armed, and blinks after an alarm is
triggered at any zone. Blinking indicates alarm history in memory.
Green STATUS Indicator
- Blinks when zone/s is/are troubled, remains lit as long as zones are
not troubled, rapid blinking during Tamper alarm.
Yellow SHUNT (Bypass) Indicator
- Lights up upon zone bypass.
(Note: may light automatically upon arming if Auto Bypass was programmed).
The indicator also lights up and blinks upon Group Bypass entry (by pressing ‘0’ twice).
Red FIRE (Trouble) Indicator
- Rapid blinking when a Fire Zone is troubled.
Two LEDs flashing (Left Most LEDs)
- In user code programming mode, rapid blinking
indicates code or code index to be entered. In Installer programming mode, it indicates address entry.
In Disarmed mode, the 2 left-most LEDs blinking indicate 24H-alarm mode. Zone number will also
be displayed.
Three LEDs Flashing
- In Disarmed mode, rapid blinking indicates AC power failure. AC
power fail event is displayed in Events History as three lines
. Starting version 2.11 the LEDs will
blink for six seconds every minute (to save energy).
In Armed mode, rapid blinking indicates system restored after AC Power Failure mode.
During programming Follow-Me Telephone Number via AV-701 Keypad, three flashing LEDs
indicate that a new telephone number may be programmed.
Four LEDs Flashing
- Upon holding-down key ‘8,’ the system is ready for code to be
entered. (Same LED indication when code is expected for Bypass via code.)
