20
3.7
Remote Key and Wireless Arming & Disarming
EasyLoader
Series enables Arming/Disarming by remote momentary or latch key-switch (as
programmed in address 071), which is connected to terminals ‘KE’ and ‘- Aux. Power.’
When using remote key-switch, wire length should not exceed 10 meters.
Momentary or Latch pulse (programmable) between ‘KEY’ and ‘-V’ terminals will Arm and
Disarm the control panel. (Prior to arming, the ‘instant’ and ‘24H’ zones should be closed.)
System reverts to previous status with next momentary pulse (refer to Wiring Diagram.)
For Arming/Disarming via Wireless Radio Remote, connect receiver's relay to ‘KE’ and
‘- Aux. Power’ terminals. Verify the receiver relay mode, momentary, or latch, and set system
accordingly. Arming via key is indicated as event in history log.
For fully compatible trouble-free operation, AV-GAD's A11RX or A22RX wireless sets are
recommended. Programmable option: Arm with wireless with automatic Group bypass.
3.8
Auto Arming
Auto Arming provides automatic arming at pre-programmed time.
Setting the time for Automatic Arming:
- By Installer
: Program (or display) hours and minutes at address 016.
- By User
: Enter to user-programming mode. Hold down '8', 'A' is displayed; type hour and minutes
in 24 hours format. To display, hold down '8' and wait.
To disable Automatic Arming program 0000.
After Automatic Arming is programmed, the system time can be set only via User Programming
Mode: Enter User Programming Mode (hold-down 8 and 1234), hold down '1' ('t' is displayed) and
type hour and minutes. Hold down '1' and wait for the time to be displayed. Holding down keys '0'+'1'
to program the time is possible only if the Automatic Arming is disabled (otherwise an 'Error’
warning is displayed).
Automatic Arming will not operate if the time has not been set (blinking 'h'). Automatic Arming will
not operate if the control panel is already armed.
Automatic Arming will operate even if the control panel is currently in ALARM.
When the Automatic Arming programmed time arrives, the system starts at a 30-second countdown.
An 'A' is intermittently displayed and beeps are sounded at the keypad.
During the countdown period, the Automatic Arming can be aborted by entering a valid user code
(not code No. 7, if used to ‘open’ a door).
With PRO systems (in user programming mode):
To set systems clock when Auto Arming enabled: Press 20 and enter the time in 24H format, confirm
with #. Press 20 and # to display the system clock.
To set Auto Arming Time: Press 21 and enter the time in 24H format, confirm with #. Press 21 and #
to display the Auto Arming time.
