Allied Telesis AR2050V, Справочник по командам, Страница: 386 / 2824

C613-50186-01 Rev B Command Reference for AR2050V 386
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
I
NTERFACE
C
OMMANDS
SHOW INTERFACE STATUS
show interface status
Overview Use this command to display the status of the specified interface or interfaces.
Note that when no interface or interfaces are specified then the status of all
interfaces on the device are shown.
Syntax
show interface [< port-list >] status
Examples To display the status of ports 1.0.1 to 1.0.4, use the commands:
awplus# show interface port1.0.1-1.0.4 status
To display the status of all ports, use the commands:
awplus# show interface status
Parameter Description
<port-list>
The ports to display information about. The port list can be:
• a switch port (e.g. port1.0.6), a static channel group (e.g. sa2) or a
dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.6, or sa1-2, or po1-2
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix switch ports, static channel
groups, and dynamic (LACP) channel groups in the same list
Table 10: Example output from the show interface <port-list> status command
awplus#show interface port1.0.1-1.0.4 status

Port Name Status Vlan Duplex Speed Type

port1.0.1 notconnect 1 auto auto 1000BASE-T

port1.0.2 notconnect 1 auto auto 1000BASE-T

port1.0.3 notconnect 1 auto auto 1000BASE-T

port1.0.4 notconnect 1 auto auto 1000BASE-T
Table 11: Example output from the show interface status command
awplus#sho int status

Port Name Status Vlan Duplex Speed Type

port1.0.1 Trunk_Net connected trunk a-full a-1000 1000BaseTX

port1.0.2 Access_Net1 connected 5 full 1000 1000BaseTX

port1.0.3 Access_Net1 disabled 5 auto auto 1000BaseTX

port1.0.4 Access_Net2 connected 6 auto auto 1000BaseTX

...

eth2 notconnect none auto auto 1000BASE-T

eth1 notconnect none auto auto 1000BASE-T