C613-50186-01 Rev B
Command Reference for AR2050V
1878
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
A
UTHENTICATION
C
OMMANDS
SHOW
AUTH
DIAGNOSTICS
show auth diagnostics
Overview
This command shows authentication diagnostics, optionally for the specified
interface, which may be an Ethernet port.
If no interface is specified then authentication diagnostics are shown for all
interfaces.
Syntax
show auth diagnostics [interface <
interface-list
>]
Mode
Privileged Exec
Example
To display authentication diagnostics for
eth1
, enter the command:
awplus#
show auth diagnostics interface eth1
Output
Figure 39-2:
Example output from the
show auth diagnostics
command
Parameter
Description
interface
Specify ports to show.
<interface-list>
The interfaces or ports to configure. An interface-list can be:
•
an interface (e.g.
eth1
)
•
a continuous range of interfaces, e.g.
eth1-2
•
a comma-separated list of the above; e.g.
eth1, eth2
.
The specified interfaces must exist.
Authentication
Diagnostics for interface eth1
Authentication Diagnostics
for interface port1.0.6
Supplicant address: 00d0.59ab.7037
authEnterConnecting: 2
authEaplogoffWhileConnecting: 1
authEnterAuthenticating: 2
authSuccessWhileAuthenticating: 1
authTimeoutWhileAuthenticating: 1
authFailWhileAuthenticating: 0
authEapstartWhileAuthenticating: 0
authEaplogoggWhileAuthenticating: 0
authReauthsWhileAuthenticated: 0
authEapstartWhileAuthenticated: 0
authEaplogoffWhileAuthenticated: 0
BackendResponses: 2
BackendAccessChallenges: 1
BackendOtherrequestToSupplicant: 3
BackendAuthSuccess: 1