Allied Telesis AR2050V, Справочник по командам, Страница: 1268 / 2824

C613-50186-01 Rev B Command Reference for AR2050V 1268
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
BGP
AND
BGP4+ C
OMMANDS
NEIGHBOR RESTART
-
TIME
neighbor restart-time
Overview Use this command to set a different restart-time other than the global restart-time
configured using the
bgp graceful-restart command for BGP and BGP4+.
Use the no variant of this command to restore the device to its default state (see
the default value of the bgp graceful-restart command).
Syntax
neighbor < neighborid > restart-time < delay-value >
no neighbor < neighborid > restart-time < delay-value >
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] Router Configuration
Usage This command takes precedence over the restart-time value specified using the
bgp graceful-restart command.
The restart-time value is the maximum time that a graceful-restart neighbor waits
to come back up after a restart. The default is 120 seconds.
Make sure that the restart time specified using this command does not exceed the
stalepath-time specified in the Router Configuration mode.
Parameter Description
< neighborid > {
<ip-address>
|
<ipv6-addr>
|
<peer-group>
}
<ip-address>
Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr>
Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group>
Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the
neighbor peer-group (add a
neighbor) command, and neighbor route-map
command. When this parameter is used with
this command, the command applies on all
peers in the specified group.
< delay-value >
< 1-3600 > Delay value in seconds.