C613-50186-01 Rev B
Command Reference for AR2050V
2610
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
F
IREWALL
C
OMMANDS
SHOW
FIREWALL
CONNECTIONS
LIMITS
CONFIG
-
CHECK
show firewall connections limits
config-check
Overview
Use this command to check configuration validity of firewall connection limits.
An invalid rule will not be active and cannot be hit. This command also shows the
reasons why a limit configuration is not valid.
Syntax
show firewall connections limits config-check
Mode
Privileged Exec
Usage
Firewall limits are applied to entities only. A limit is not valid if the source entity
(zone) is not configured properly. This command checks if the entity exists at all,
and if it does it also checks if the entity (zone) has a valid subnet.
Examples
To check configuration validity of connection-limit rules, use the command:
awplus#
show firewall connections limits
config-check
Output
Figure 56-6:
Example output from the
show firewall connections limits
config-check
command on the console if rule configuration errors
are detected. Connection-limit 10 uses an entity that exists;
however no subnet has been specified. Connection-limit 20 uses an
entity that doesn't exist.
Output
Figure 56-7:
Example output from the s
how firewall connections limits
config-check
command if all limit rules are valid
Related
commands
show firewall connections limits
awplus#show firewall connections limits config-check
Connection-limit 10:
"From" entity has no subnet or host addresses
Connection-limit 20:
"From" entity does not exist
awplus#show firewall connection limits config-check
All rules are valid