Agilent Technologies 53220A, Руководство пользователя

Страница: 3 / 294

53220A/53230A User’s Guide 3
Waste Electrical and
Electronic Equipment (WEEE)
Directive 2002/96/EC
This product complies with the WEEE Direc-
tive (2002/96/EC) marking requirement.
The affixed product label (see below) indi-
cates that you must not discard this electri-
cal/electronic product in domestic
household waste.
Product Category : With reference to the
equipment types in the WEEE directive
Annex 1, this product is classified as a
"Monitoring and Control instrumentation"
product.
Do not dispose in domestic household
waste.
To return unwanted products, contact your
local Agilent office, or see
www.agilent.com/environment/product
for more information.
Lithium Battery Recycling
The 53220A/53230A counters contain a 3V
“coin cell” lithium battery. Agilent recom-
mends that this battery be replaced every
year at the instrument’s 1-year calibration
interval. Replacement procedures are pro-
vided in the 53220A/53230A Service Guide.
Option 300 provides battery operation of the
53220A/53230A using a 12 lithium battery.
Performance of this battery will degrade
over time as a function of the number of bat-
tery charge/discharge cycles.
Refer to local, state, or Federal regulations
when disposing of, or recycling either bat-
tery.
Safety Information
The following general safety precautions
must be observed during all phases of oper-
ation of this instrument. Failure to comply
with these precautions or with specific
warnings or operating instructions in the
product manuals violates safety standards
of design, manufacture, and intended use of
the instrument. Agilent Technologies
assumes no liability for the customer's fail-
ure to comply with these requirements.
General
Do not use this product in any manner not
specified by the manufacturer. The protec-
tive features of this product may be
impaired if it is used in a manner not speci-
fied in the operation instructions.
Before Applying Power
Verify that all safety precautions are taken.
Note the instrument's external markings
described under "Safety Symbols".
Ground the Instrument
The Agilent 53220A/53230A is provided
with a grounding-type power plug. The
instrument chassis and cover must be con-
nected to an electrical ground to minimize
shock hazard. The ground pin must be firmly
connected to an electrical ground (safety
ground) terminal at the power outlet. Any
interruption of the protective (grounding)
conductor or disconnection of the protec-
tive earth terminal will cause a potential
shock hazard that could result in personal
injury.
Fuses
The Agilent 53220A/53230A is provided
with an internal line fuse appropriate for the
line voltages listed on the instrument. This
fuse is not user accessible.
Do Not Operate in an Explosive
Atmosphere
Do not operate the instrument in the pres-
ence of flammable gases or fumes.
Do Not Operate Near
Flammable Liquids
Do not operate the instrument in the pres-
ence of flammable liquids or near contain-
ers of such liquids.
Do Not Remove the Instrument
Cover
Only qualified, service-trained personnel
who are aware of the hazards involved
should remove instrument covers. Always
disconnect the power cable and any exter-
nal circuits before removing the instrument
cover.
Do Not Modify the Instrument
Do not install substitute parts or perform
any unauthorized modification to the prod-
uct. Return the product to an Agilent Sales
and Service Office for service and repair to
ensure that safety features are maintained.
In Case of Damage
Instruments that appear damaged or defec-
tive should be made inoperative and
secured against unintended operation until
they can be repaired by qualified service
personnel.
Cleaning the Instrument
Clean the outside of the instrument with a
soft, lint-free, slightly-dampened cloth. Do
not use detergents or chemical solvents.