Zero88 FROG 2, Operating Manual

Page: 120 / 184

Cues, Stacks and Pages
Page 120 Frog 2 Operating Manual – Issue 4.3
Speed
The Speed modifier determines how fast the chase runs (range 0 – 200 bpm).
When the Speed is set to zero, the chase runs according to the delay and fade times that
are programmed into each step (cue) in the chase.
When the Speed is set to a value between 1 and 200, the chase runs at the corresponding
number of beats per minute (bpm). All the fade and delay times that are programmed in
the steps (cues) are ignored and the transition between each step (cue) is determined by
the Fade modifier (see below).
Fade
The Fade modifier determines how the outputs ‘fade’ between the steps (cues) when the
speed is set between 1 – 200 bpm.
When the Fade is set to 0% the outputs snap between each step of the chase.
When the fade is set to 100% the outputs fade continuously between each step.
When the fade is set between 0 - 100% the outputs will spend that percentage of the time
fading, and the rest of the time at the programmed level for the step.
The Fade modifier affects all fixture parameters programmed in the cues.
Shots
The Shots modifier determines how many times the chase will run after being triggered.
When Shots is set to zero, the chase runs continuously.
When Shots is set to a value between 1 and 255, the chase runs the specified number of
times and then stops on the last step.
Note – If the Direction modifier is set to Random, then one ‘shot’ is defined as outputting N
steps, where N is the total number of steps (cues) in the cue stack.
Revert From Chase
To return a cue stack from a chase to a normal cue stack, press the [Revert From Chase]
button in the Stack Setup Window.