Zero88 FROG 2, Operating Manual

Page: 28 / 184

Quick Start Tutorial
Page 28 Frog 2 Operating Manual – Issue 4.3
Controlling Intensity
The intensity parameter of the selected fixture(s) can be controlled by entering commands
directly via the numeric keypad or by using the corresponding control wheel.
Direct Commands
Intensity levels can be set for a complete group of fixtures using the following commands:
GROUP <select group> @ N ENTER sets the intensity output to N %.
GROUP <select group> FULL ENTER sets the intensity output to 100 %.
Intensity levels can also be set for a single fixture or a number of fixtures within a group.
First select the group and then use any of the following commands:
1 @ N ENTER sets the intensity output of fixture 1to N %.
1 FULL ENTER sets the intensity output of fixture 1to 100 %.
2 + 3 @ N ENTER sets the intensity output of fixtures 2 and 3 to N %.
2 + 3 FULL ENTER sets the intensity output of fixtures 2 and 3 to 100 %.
5 THRU 10 @ N ENTER sets the intensity output of fixtures 5 to 10 to N %.
5 THRU 10 FULL ENTER sets the intensity output of fixtures 5 to 10 to 100 %.
Using the Control Wheel
The Intensity channel of a fixture can also be adjusted by control wheel.
First select the fixture(s) required as described above and then press the POSITION
attribute key (if not already selected). The intensity parameter is assigned to the second
finger wheel.
Use the control wheel to adjust the intensity level as required. The output value is shown
on the touch screen above the corresponding control wheel.
Tip – No Intensity Output ?
If the intensity output levels do not change when you send any of the above commands to
a fixture, or adjust the intensity level using the wheel, check that the GRAND MASTER
fader is at full and the BLACKOUT button is off. If the selected fixture(s) have a Shutter
parameter, check that the shutter is open. Check that the Highlight key is not selected.