Zeiss opmi lumera 700, Instructions For Use Manual

Page: 92 / 236

4 Installation Instructions for Use
OPMI LUMERA 700 4.3 Connections
92 / 236 G-30-1673-en - 14.0 - 2018-07-12
4.3 Connections
4.3.1 Connecting the power supply
1
230 V
115 V
2
3
Figure 55: Connecting the power supply
1 Sliding switch for rated
voltage 2 Power inlet socket
3 Potential equalization connector
WARNING!
Risk of injury caused by electrical voltage!
u
To prevent the risk of electric shock, this device may only be
connected to a power grid which is connected to a flawless
protective ground conductor.
NOTE
Device damage resulting from incorrect rated voltage
setting!
u
Check to make sure the rated voltage sliding switch corre-
sponds to the rated voltage of the net available at the site of
installation.
u
If the rated voltage is not correctly set, adjust the sliding switch
using a suitable tool.
Material • Included power cord
Prerequisite
þ
The power switch is off.
þ
The sliding switch's rated voltage corresponds to the rated
voltage of the net available at the site of installation. Possible
values are 115 V / 230 V, 50-60 Hz.
Action 1. Plug the included power cord into the power inlet socket.
2. Plug the power cord into the power outlet.
3. Secure the power cord using the strain relief device [ } 104].
4. If required: connect the potential equalization connector to the
equipotential bonding bar in the OR.