Zeiss opmi lumera 700, Instructions For Use Manual

Page: 195 / 236

Instructions for Use 10 Troubleshooting
OPMI LUMERA 700 10.4 Troubleshooting work
G-30-1673-en - 14.0 - 2018-07-12 195 / 236
CAUTION!
Risk of injury caused by lamp rupture!
Lamp rupture may lead to jamming of the lamp module and failure
of the electronics modules.
u
The lamp module may be changed only by appropriately
trained personnel.
u
Before opening the lamp housing: move the device to a
position in which falling particles cannot put the patient or user
at risk.
u
If the lamp module is blocked or illumination is no longer
operable, the device may not be used any longer. Contact ZEISS
Service.
Material • Xenon backup lamp module with 2 xenon
lamps for Superlux Eye
Prerequisite
þ
The power switch is off.
Action 1. Press the [Open lamp module] button.
ð
The lamp module will eject partially.
2. Slide the original transport case over the module until the bolt
snaps into the borehole. This unlocks the stop.
3. NOTE! Using the correct lamp module. Use only the
backup lamp module prescribed above.
Remove the old
lamp module and insert the backup module.
4. Turn on the device at the power switch.
5. Check the function of the xenon lamp and backup xenon lamp.
6. Reset the remaining service hours counter to its initial value of
500.
7. Package the old lamp module in the backup lamp module's
original transport packaging.
8. Fill in the enclosed return card and send the old lamp module
to ZEISS Service.
Use only the original transport packaging! It features explosion
protection for potentially defective xenon lamps.
10.4.6 Setting the gas spring on the integrated 22" monitor
If the integrated 22" monitor is lowering on its own, the gas spring
on the suspension arm can be readjusted.
Tools • M5 hex key
Action 1. Align the suspension arm and the support arm horizontally.
2. Tighten the hexagon socket screw on the gas spring clockwise
(+) until the integrated 22" monitor remains in the desired
position.