116
YASKAWA
SIEP C730600 0DB EtherNet/IP Technical Manual
Figure 15.6 Email Alerts Page View
Procedure: Conditional Email Set-up
1. Click the [Enable] check box to enable the alert.
2. Define the condition that will trigger the email by selecting a monitor parameter, a comparator, and a value.
Set the conditions to send alerts from the [Condition] drop-down selection. If choosing only one condition and
no OR or AND are needed, set the [OR/AND] drop-down selection to [—].
3. Enter the email address where the alert will be sent.
4. Enter the message that will appear in the email contents.
5. Enter the email subject.
◆
Parameter Access Page
The Parameter Access page allows the user to read and write parameters from the drive. Write access is restricted
until a valid password is entered.
Figure 15.7 Parameter Access Page View
The MEMOBUS/Modbus address for the drive parameter being accessed must be entered in hexadecimal.
Clicking [Read] will load and display the current value of the given MEMOBUS/Modbus Address.
Clicking [Set] will save the given value to the given MEMOBUS/Modbus address.
After a [Read] or [Set] command is given, Status will display [Waiting] while the action is being carried out, then
[Read Successful] or [Write Successful] is displayed when finished.
