28
YASKAWA
SIEP C730600 0DB EtherNet/IP Technical Manual
3.
Remove the screw (B) installed in the drive grounding terminal (A).
A - Drive grounding terminal (FE)
B - Ground screw
Figure 5.23 Remove the Screw from the Drive Grounding Terminal
4.
Use the screw (B) installed in the FE ground terminal of the drive (A) to connect one end of the included
ground wire (C) to the ground terminal on the drive.
Tighten the screw to a correct tightening torque:
• 0.5 N
∙
m to 0.6 N
∙
m (4.4 in
∙
lb to 5.3 in
∙
lb)
Note:
Route ground wire on the right side of the stud (D).
A - Drive grounding terminal (FE)
B - Ground screw
C - Ground wire
D - Stud
Figure 5.24 Connect the Ground Wire
5.
Install the option (A) into the connector (C) (HV600: CN5, FP605: CN5-A) on the drive and use the
included screw (B) to put it in place.
Tighten the screw to a correct tightening torque:
• 0.5 N
∙
m to 0.6 N
∙
m (4.4 in
∙
lb to 5.3 in
∙
lb)
