Yamaha WR426F(P), Owner'S Service Manual

Page: 302 / 776

3 - 31
INSP
ADJ
REAR BRAKE PAD INSPECTION AND REPLACEMENT
●
Remove the pad pin 6 and brake pads 7 .
●
Connect the transparent hose
8
to the
bleed screw 9 and place the suitable con-
tainer under its end.
●
Loosen the bleed screw and push the cali-
per piston in.
CAUTION:
Do not reuse the drained brake fluid.
●
Tighten the bleed screw.
T
R
.
.
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
●
Install the brake pad 0 and pad pin A .
NOTE:
●
Install the brake pads with their projections
a
into the caliper recesses
b
.
●
Temporarily tighten the pad pin at this
point.
●
Install the caliper B and rear wheel C .
Refer to “FRONT WHEEL AND REAR
WHEEL” section in the CHAPTER 5.
●
Tighten the pad pin D .
T
R
.
.
Pad pin:
18 Nm (1.8 m • kg, 13 ft • lb)
●
Install the pad pin plug E and protector F .
T
R
.
.
Pad pin plug:
3 Nm (0.3 m • kg, 2.2 ft • lb)
Bolt (protector):
7 Nm (0.7 m • kg, 5.1 ft • lb)