Yamaha EF2000iS - Inverter Generator, Service Manual

Page: 82 / 312

2-25
OVERLOAD WARNING LIGHT
INSP
ADJ
3. Check for blockages in the cooling air inlet
and around the control unit. If any block-
ages are found, remove.
4. After checking, restart the engine.
TIP
The overload warning light may come on for a
few seconds at first when using electric
devices that require a large starting current,
such as a compressor or a submergible pump.
However, this is not a malfunction.
5. Check:
9
Overload warning light
1
lighting
6. Remove:
9
Fuel cock knob
9
Control panel
9
Overload warning light connector
Refer to “CONTROL PANEL” in CHAP-
TER 3.
å
For Canada and Australia
∫
For Europe and Korea
Checking steps:
9
Connect a size AA battery (1.5 V) to the
overload warning light lead.
9
Check that the overload warning light
1
turns on.
Does not turn on
→
Replace.
TIP
battery (+)
→
Yellow lead
a
battery (–)
→
Black/White lead
b
7. Install:
9
Overload warning light connector
9
Control panel
Refer to “CONTROL PANEL” in CHAP-
TER 3.
9
Fuel cock knob
å
For Canada and Australia
∫
For Europe and Korea
1
1
A
B
a
b
1
a
b
A
B
7DK40-02 6/15/09 2:58 PM Page 51