Xante Accel-a-Graphix CT4, User Manual

Page: 174 / 310

6-46 Routine Operations bb __________________________________
You can independently control spooling to each controller interface
in two ways. You can use the front panel, or you can use Command
Center. This section covers both ways.
Note: Command Center not only controls spooling, but it also
provides access to all the features for spooling and its job
queue. The Save Spooled Job option in the controller’s PPD
features allow you to save a file in a special section of the
controller’s hard disk. See “Save Spooled Job” earlier in this
chapter for details.
Front Panel Spooling
To set an interface for spooling through the front panel
Note: This example enables the spooling feature on the parallel
interface.
1. Press the Menu
→
key until SETUP:IF appears in the window.
Then, select the Enter
↓
key to select that menu.
2. Press the Menu
→
key until IF:PARALLEL appears in the
window. Then, press the Enter
↓
key to select that interface.
3. Press the Menu
→
key until PARALLEL:SPOOL appears in
the window. Then, press the Enter
↓
key to select the Spool
menu.
4. Press the Menu
→
key until spool:yes appears, if necessary. If
the menu name is capitalized, then spooling is already the
default setting; skip to step 6.
5. Press the Enter
↓
key to select yes. The selection changes to all
capital letters, SPOOL:YES, in the window.
6. Press the On Line key. READY/IDLE appears in the window.
The controller now has spooling as the default setting.