Summary
CHAPTER
6
Detailed Parameter Description
6.1 Access and Read Only Parameters - P000 to P099.........................87
6.2 Regulation Parameters - P100 to P199 ............................................97
6.3 Configuration Parameters - P200 to P299
........................................106
6.4 Serial Communication Parameters - P300 to P399 ..........................119
6.5 Motor Parameters - P400 to P499 ....................................................121
6.6 Special Function Parameters - P500 to P599 ..................................122
6.7 Protection Parameters - P600 to P699 .............................................128
6.8 Selection Between Fault and Alarm - P700 to P790 ........................140
6.9 SoftPLC Parameters - P950 to P999
................................................142
CHAPTER
7
Programming Information and Suggestions
7.1 Applications and Programming .........................................................143
7.1.1 Starting by Voltage Ramp (P202=0) ...........................................145
7.1.2 Starting by Current Limit (P202=1)
.............................................146
7.1.3 Starting by Current Ramp with High Initial Current (P202=4) .....147
7.1.4 Starting by Current Ramp with Low Initial Current (P202=4)
.....148
7.1.5 Starting with Pump Control (P202=2) .........................................149
7.1.6 Starting with Torque Control (P202=3) .......................................151
7.1.6.1 Loads with Constant Torque (P202=3 and P120=1 point)
..152
7.1.6.2 Loads with Higher Initial Torque
(P202=3 and P120=3 points) .............................................152
7.1.6.3 Loads with Constant Torque and S Speed Curve
(P202=3 and 120=3 points) ................................................153
7.1.6.4 Loads with Quadratic Torque and S Speed Curve
(P202=3 and P120=2 points) ..............................................153
7.1.6.5 Loads with Quadratic Torque and Linear Speed Curve
(P202=3 and P120=3 points) .............................................154
7.1.6.6 Loads with Quadratic Torque and Higher Initial Torque
(P202=3 and P120=3 points) ..............................................154
7.1.6.7 Hydraulic Pump Load Type (P202=3)
................................155
7.2 Protections and Programming ..........................................................158
7.2.1 Thermal Classes.........................................................................158
7.2.1.1 Suggestions on How to Set Thermal Class ........................158
7.2.1.2 Example on How to Set the Thermal Class ........................159
7.2.1.3 Time Reduction When Changing from Cold Starting to
Hot Starting ........................................................................160
7.2.1.4 Service Factor ....................................................................160
7.2.2 Under- and Over- Protections ....................................................161
7.2.2.1 Undervoltage and Overvoltage protection ..........................161
7.2.2.2 Underload Protection ..........................................................161
7.2.2.3 Overload Protection ............................................................161
Summary of Contents for SSW06
Page 2: ......
