Volkswagen CC 2012, Workshop Manual

Page: 143 / 222

– Connect voltage tester - V.A.G 1527B- with cables from aux‐
iliary measuring set - V.A.G 1594C- to battery positive (+)
(connection in engine compartment -arrow-) and oil pressure
switch. LED must not light up.
If the LED lights up:
– Replace oil pressure switch - F1-
If LED does not light up:
Note
Observe the tester and LED while starting because the switching
point of the oil pressure switch may already be exceeded when
starting.
– Start engine and run at idling speed. At 0.7…1.1 bar the LED
must light up; otherwise renew oil pressure switch - F1- .
Checking oil pressure:
– Check oil pressure at various speeds:
♦ 1500 rpm: at least 1.7 bar
♦ 2000 rpm: 3.0 … 5.5 bar
♦ Over 2,000 rpm: maximum 7.0 bar
If the specifications are not attained:
– Check strainer in oil suction pipe
⇒ Item 12 (page 123) for dirt.
– Check control piston of oil pressure safety valve in oil pump
for dirt.
– Check oil pipe at bottom of cylinder block
⇒ Item 14 (page 124) for leaks.
Note
♦
Mechanical damage, e.g. to bearings, could also be the cause
for oil pressure being too low.
♦
The oil pressure safety valve control piston is spring-loaded.
Great care is therefore required when screwing the plug in/out.
♦
The plug is tightened to 35 Nm in oil pump.
If no fault is found:
– Renew oil pump
⇒ page 127 .
If the specification is exceeded:
– Check oil channels.
– Renew oil pump, if necessary
⇒ page 127 .
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
2. Oil filter, oil pressure switch
137