Videonics PowerScript PS4000S, Instruction Manual

Page: 36 / 236

Chapter 2 Equipment Setups
26
C
OMPLETING THE
S
ETUP
The normal, default setup is for your configuration to use two monitors—Preview and
Program. Therefore, in most circumstances you don’t need to do anything further to
complete your setup. However, if you want to confirm that your setup is correct, or if
both monitors don’t work correctly after you start PowerScript, use the following proce-
dure to verify your settings.
You can perform the following setup steps when you do “Lesson 1 Getting Started” in
Chapter 3,
PowerScript Tutorial . That lesson shows you how to start PowerScript and
access the MAIN MENU . In that case, you can skip steps 1 and 2, below.
To configure PowerScript to use two monitors:
1 Start PowerScript. See “Starting and Stopping PowerScript” on page 88 for instructions.
2
Enter Ctrl+Right-click to display the MAIN MENU.
3
Click the Setup option.
4 When the SETUP menu appears, click the Display Parameters option to display this
menu.
5
Select the dual monitor option (2) in the Monitors section.
For additional information, see “Display Parameters” on page 122.
6
Click the Close Box to close the SETUP menu.
Setup Option
75% 100%
(NORMAL)
AUTO
SETUP: DISPLAY
Video
2
1
Select Dual Monitor option
Close Box