Trend Micro InterScan M Series, Administrator'S Manual

Page: 36 / 480

Trend Micro™ InterScan™ Gateway Security Appliance M-Series Administrator’s Guide
1
-
16
static IP address, you will need to use the buttons on the LCD module to set the
netmask address, default gateway address, and primary DNS address. You can
also designate a host name in this way.
Note: You may also be required to provide a secondary DNS server address.
See Chapter 2,
Deployment Options
for full deployment instructions.
Connecting to the Network
With a DHCP server, you can connect InterScan Gateway Security Appliance to your
network right out of the box without having to undergo a preconfiguration process.
Once connected, InterScan Gateway Security Appliance can handle various interface
speeds and duplex mode network traffic.
To connect the InterScan Gateway Security Appliance to your network:
1. Connect one end of the Ethernet cable to the INT port (right side) and the other
end to the segment of the network that InterScan Gateway Security Appliance
will protect (the Protected Network).
2. Connect one end of another Ethernet cable to the EXT port (left side) and the
other end to the part of the network that leads to the public network.
3. Using the power switch in the back of the appliance, power on the device.
Note: To prevent accidental shutdown of the appliance, the appliance power switch has
been modified from the standard On/Off convention. To power on InterScan
Gateway Security Appliance, simply press the Power Switch upward from the 0 to
1 position. To power off InterScan Gateway Security Appliance, press the power
switch upward from 0 to 1 and
hold it in that position for a minimum of five
seconds, until the appliance powers off.