Trend Micro InterScan M Series, Administrator'S Manual

Page: 328 / 480

Trend Micro™ InterScan™ Gateway Security Appliance M-Series Administrator’s Guide
15
-
8
To connect the local computer to the appliance:
1. Connect an Ethernet cable to the appliance Management port (for option 5) or the
INT port (for option 3) on the back of the device, as shown in the figure below,
and connect the other end of the cable the local computer.
F
IGURE
15-1.
Back panel of appliance showing console port,
management port, and INT port
2. If uploading with option 5, change the IP address of the local computer to
192.168.252.x and the subnet mask to 255.255.255.0, while being careful to
avoid the IP addresses 192.168.252.1 and 192.168.252.2 to avoid an IP conflict,
as these are the default IP addresses for the appliance rescue mode and for the
appliance BMC (baseboard management controller) respectively. (See
Getting
the IP Address of the Local PC on page 15-12.)
3. If uploading with option 3, ensure that the IP address of the local computer is in
the same segment as the appliance IP address. (See
Getting the IP Address of the
Local PC on page 15-12.)
4. Connect a serial (RS 232) cable from the local computer to the serial port on the
back panel of the appliance. (See figure 15-1 on page 8 for location of the serial
port.
Console port
INT port (for option 3)
Management port (for option 5)