Trend Micro InterScan M Series, Administrator'S Manual

Page: 336 / 480

Trend Micro™ InterScan™ Gateway Security Appliance M-Series Administrator’s Guide
15
-
16
2. Connect an RJ45 Ethernet cable from your local computer to the
INT
port of the
appliance, as shown below.
F
IGURE
15-10. The appliance back panel showing location of internal
(INT) port
3. Upload the new device image by using the Trend Micro Appliance Firmware
Flash Utility as described in
Using the Appliance Firmware Flash Utility with
Option 3 on page 15-16.
Using the Appliance Firmware Flash Utility with Option 3
Before launching the Appliance Firmware Flash Utility (AFFU), ensure that the IP of
your PC is within the same segment as the IP of the appliance.The appliance IP
address appears on the preconfiguration console screen that appears when you select
option 3 -
Update Device Image & Keep Current Configuration
(see figure 15-9, Preconfiguration console screen that appears when you select
option 3 in rescue mode ).
To upload the device image update with option 3 using the AFFU:
1. Put the appliance Solutions CD into the local computer. The following screen
appears:
Internal (INT) port