![background image](http://html1.mh-extra.com/html/thermofisher-scientific/dxr-xi/dxr-xi_user-manual_1105625058.webp)
Servicing the Microscope
52
DXRxi User Guide
Thermo Scientific
Replacing the Nosepiece
Figure 56.
Replacing the nosepiece
When installing a nosepiece, make sure to slide it in until it stops, and then tighten the screw
until it is just tight. Do not over tighten.
When installing a new nosepiece or changing objectives, set the Objective selection in the
software to the new objective you will be using.
Replacing an Illuminator Bulb
Time needed:
Approximately 10 minutes
Tools needed:
A 3.0 mm hex wrench
Parts needed:
Replacement illuminator bulbs (contact us for ordering information)
Tip
Do not remove the screw because it is difficult to replace.
Note
If you suspect a brightfield or transmission illuminator needs to be replaced, or if
there is a problem with the illuminator, contact us.
CAUTION
Avoid fire hazard. Use only illuminator bulbs supplied by us to avoid fire
hazard.
Summary of Contents for DXR xi
