Chapter 26: Interface Commands
– 942 –
threshold-value
– The threshold of the transceiver temperature.
(Range: -12800 - 12800 in units of 0.01 Celsius)
D
EFAULT
S
ETTING
High Alarm: 75.00
C
HIgh Warning: 70.00
C
Low Alarm: -123.00
C
Low Warning: 0.00
C
C
OMMAND
M
ODE
Interface Configuration (SFP Ports)
C
OMMAND
U
SAGE
•
Refer to the Command Usage section under the
command for more information on configuring transceiver
thresholds.
•
Trap messages enabled by the
command are sent
to any management station configured by the
command.
E
XAMPLE
The following example sets alarm thresholds for the transceiver
temperature at port 1.
Console(config)interface ethernet 1/52
Console(config-if)#transceiver-threshold temperature low-alarm 97
Console(config-if)#transceiver-threshold temperature high-alarm -83
Console#
transceiver-
threshold tx-power
This command sets thresholds for the transceiver power level of the
transmitted signal which can be used to trigger an alarm or warning
message.
S
YNTAX
transceiver-threshold tx-power
{
high-alarm
|
high-warning
|
low-alarm
|
low-warning
}
threshold-value
high-alarm
– Sets the high power threshold for an alarm message.
high-warning
– Sets the high power threshold for a warning
message.
low-alarm
– Sets the low power threshold for an alarm message.
low-warning
– Sets the low power threshold for a warning
message.
threshold-value
– The power threshold of the transmitted signal.
(Range: -4000 - 820 in units of 0.01 dBm)
Summary of Contents for SSE-G2252
