Supermicro SSE-G2252, User Manual

Page: 1074 / 1401

Chapter 36: VLAN Commands
Configuring VLAN Interfaces
– 1087 –
interface vlan
This command enters interface configuration mode for VLANs, which is
used to configure VLAN parameters for a physical interface. Use the no
form to change a Layer 3 normal VLAN back to a Layer 2 interface.
S
YNTAX
[ no ] interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4094)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
•
Creating a “normal” VLAN with the vlan command initializes it as a
Layer 2 interface. To change it to a Layer 3 interface, use the interface
command to enter interface configuration for the desired VLAN, enter
any Layer 3 configuration commands, and save the configuration
settings.
•
To change a Layer 3 normal VLAN back to a Layer 2 VLAN, use the no
interface command.
E
XAMPLE
The following example shows how to set the interface configuration mode
to VLAN 1, and then assign an IP address to the VLAN:
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
R
ELATED
C
OMMANDS
shutdown (928)
interface (922)
vlan (1085)
switchport
acceptable-frame-
types
This command configures the acceptable frame types for a port. Use the
no form to restore the default.
switchport priority default Sets a port priority for incoming untagged frames IC
vlan-trunking Allows unknown VLANs to cross the switch IC
Table 36-4: Commands for Configuring VLAN Interfaces (Continued)
Command Function Mode