Chapter 14: Basic Administration Protocols
Link Layer Discovery Protocol
– 374 –
•
Email Destination Address
– Specifies the email recipients of alert
messages. You can specify up to five recipients.
•
Server IP Address
– Specifies a list of up to three recipient SMTP
servers. IPv4 or IPv6 addresses may be specified. The switch attempts
to connect to the listed servers in sequential order if the first server
fails to respond.
For host name-to-IP address translation to function properly, host name
lookup must be enabled (
“Configuring General DNS Service
), and one or more DNS servers specified (see
“Configuring a List of Name Servers” on page 613
, or
Static DNS Host to Address Entries” on page 615
).
W
EB
I
NTERFACE
To configure SMTP alert messages:
1.
Click Administration, Log, SMTP.
2.
Enable SMTP, specify a source email address, and select the minimum
severity level. Specify the source and destination email addresses, and
one or more SMTP servers.
3.
Click Apply.
Figure 14-4: Configuring SMTP Alert Messages
L
INK
L
AYER
D
ISCOVERY
P
ROTOCOL
Link Layer Discovery Protocol (LLDP) is used to discover basic information
about neighboring devices on the local broadcast domain. LLDP is a Layer 2
protocol that uses periodic broadcasts to advertise information about the
sending device. Advertised information is represented in Type Length Value
(TLV) format according to the IEEE 802.1AB standard, and can include
Summary of Contents for SSE-G2252
