Supermicro SSE-G2252, User Manual

Page: 1237 / 1401

Chapter 40: LLDP Commands
– 1250 –
E
XAMPLE
Console(config)#lldp reinit-delay 10
Console(config)#
lldp tx-delay
This command configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables. Use the
no form to restore the default setting.
S
YNTAX
lldp
tx
-delay seconds
no lldp
tx
-delay
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
D
EFAULT
S
ETTING
2 seconds
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
• The transmit delay is used to prevent a series of successive LLDP
transmissions during a short period of rapid changes in local LLDP MIB
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
• This attribute must comply with the following rule:
(4 * tx-delay)


refresh-interval
E
XAMPLE
Console(config)#lldp tx-delay 10
Console(config)#
lldp admin-status
This command enables LLDP transmit, receive, or transmit and receive
mode on the specified port. Use the no form to disable this feature.
S
YNTAX
lldp admin-status { rx-only | tx-only | tx-rx }
no lldp admin-status
rx-only - Only receive LLDP PDUs.
tx-only - Only transmit LLDP PDUs.
tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
D
EFAULT
S
ETTING
tx-rx