Chapter 39: Multicast Filtering Commands
MLD Filtering and Throttling
– 1198 –
C
OMMAND
U
SAGE
A profile defines the multicast groups that a subscriber is permitted or
denied to join. The same profile can be applied to many interfaces, but only
one profile can be assigned to one interface. Each profile has only one
access mode; either permit or deny.
E
XAMPLE
Console(config)#ipv6 mld profile 19
Console(config-mld-profile)#
R
ELATED
C
OMMANDS
permit, deny
This command sets the access mode for an MLD filter profile. Use the
no
form to delete a profile number.
S
YNTAX
{
permit
|
deny
}
D
EFAULT
S
ETTING
deny
C
OMMAND
M
ODE
MLD Profile Configuration
C
OMMAND
U
SAGE
•
Each profile has only one access mode; either permit or deny.
•
When the access mode is set to permit, MLD join reports are processed
when a multicast group falls within the controlled range. When the
access mode is set to deny, MLD join reports are only processed when a
multicast group is not in the controlled range.
E
XAMPLE
Console(config)#ipv6 mld profile 19
Console(config-mld-profile)#permit
Console(config-mld-profile)#
range
This command specifies multicast group addresses for a profile. Use the
no
form to delete addresses from a profile.
S
YNTAX
[
no
]
range low-ipv6-address
[
high
-
ipv6-address
]
low-ipv6-address
- A valid IPv6 address (X:X:X:X::X) of a multicast
group or start of a group range.
Summary of Contents for SSE-G2252
