Chapter 23: Authentication Commands
802.1X Port Authentication
– 799 –
C
OMMAND
M
ODE
Interface Configuration
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
dot1x timeout
re-authperiod
This command sets the time period after which a connected client must be
re-authenticated. Use the
no
form of this command to reset the default.
S
YNTAX
dot1x timeout re-authperiod
seconds
no dot1x timeout re-authperiod
seconds -
The number of seconds. (Range: 1-65535)
D
EFAULT
3600 seconds
C
OMMAND
M
ODE
Interface Configuration
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
dot1x timeout
supp-timeout
This command sets the time that an interface on the switch waits for a
response to an EAP request from a client before re-transmitting an EAP
packet. Use the
no
form to reset to the default value.
S
YNTAX
dot1x timeout supp-timeout
seconds
no dot1x timeout supp-timeout
seconds -
The number of seconds. (Range: 1-65535)
D
EFAULT
30 seconds
C
OMMAND
M
ODE
Interface Configuration
C
OMMAND
U
SAGE
This command sets the timeout for EAP-request frames other than EAP-
request/identity frames. If dot1x authentication is enabled on a port, the
Summary of Contents for SSE-G2252
