Chapter 35: ERPS Commands
– 1051 –
and normal traffic will begin to flow in the data VLANs. To stop a ring, it
can be disabled on any node using the
no
command.
8.
Display ERPS status information: Use the
command to
display general ERPS status information or detailed ERPS status
information for a specific ring.
erps
This command enables ERPS on the switch. Use the
no
form to disable this
feature.
S
YNTAX
[
no
]
erps
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
ERPS must be enabled globally on the switch before it can enabled on an
command.
E
XAMPLE
Console(config)#erps
Console(config)#
R
ELATED
C
OMMANDS
erps domain
This command creates an ERPS ring and enters ERPS configuration mode
for the specified domain. Use the
no
form to delete a ring.
S
YNTAX
erps domain ring-name
[
id ring-id
]
no
erps domain
ring-name
- Name of a specific ERPS ring. (Range: 1-12 characters)
ring-id - ERPS ring identifier used in R-APS messages.
(Range: 1-255)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
Summary of Contents for SSE-G2252
