Chapter 20: System Management Commands
Line
– 680 –
Console(config-line)#databits 7
Console(config-line)#
R
ELATED
C
OMMANDS
exec-timeout
This command sets the interval that the system waits until user input is
detected. Use the
no
form to restore the default.
S
YNTAX
exec-timeout
[
seconds
]
no exec-timeout
seconds
- Integer that specifies the timeout interval.
(Range: 60 - 65535 seconds; 0: no timeout)
D
EFAULT
S
ETTING
10 minutes
C
OMMAND
M
ODE
Line Configuration
C
OMMAND
U
SAGE
•
If user input is detected within the timeout interval, the session is kept
open; otherwise the session is terminated.
•
This command applies to both the local console and Telnet connections.
•
The timeout for Telnet cannot be disabled.
•
Using the command without specifying a timeout restores the default
setting.
E
XAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#exec-timeout 120
Console(config-line)#
login
This command enables password checking at login. Use the
no
form to
disable password checking and allow connections without a password.
S
YNTAX
login
[
local
]
no login
Summary of Contents for SSE-G2252
