Chapter 20: System Management Commands
Event Logging
– 692 –
R
ELATED
C
OMMANDS
logging trap
This command enables the logging of system messages to a remote server,
or limits the syslog messages saved to a remote server based on severity.
Use this command without a specified level to enable remote logging. Use
the
no
form to disable remote logging.
S
YNTAX
logging trap
[
level
level
]
no logging trap
[
level
]
level
- One of the syslog severity levels listed in the table on
. Messages sent include the selected level through level 0.
D
EFAULT
S
ETTING
Disabled
Level 7
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
•
Using this command with a specified level enables remote logging and
sets the minimum severity level to be saved.
•
Using this command without a specified level also enables remote
logging, but restores the minimum severity level to the default.
E
XAMPLE
Console(config)#logging trap 4
Console(config)#
clear log
This command clears messages from the log buffer.
S
YNTAX
clear log
[
flash
|
ram
]
flash
- Event history stored in flash memory (i.e., permanent
memory).
ram
- Event history stored in temporary RAM (i.e., memory flushed
on power reset).
D
EFAULT
S
ETTING
Flash and RAM
Summary of Contents for SSE-G2252
