Chapter 17: IP Services
Domain Name Service
– 614 –
CLI R
EFERENCES
•
•
C
OMMAND
U
SAGE
•
To enable DNS service on this switch, configure one or more name
servers, and enable domain lookup status (see
DNS Service Parameters” on page 611
•
When more than one name server is specified, the servers are queried
in the specified sequence until a response is received, or the end of the
list is reached with no response.
•
If all name servers are deleted, DNS will automatically be disabled. This
is done by disabling the domain lookup status.
P
ARAMETERS
These parameters are displayed:
Name Server IP Address
– Specifies the IPv4 or IPv6 address of a
domain name server to use for name-to-address resolution. Up to six IP
addresses can be added to the name server list.
W
EB
I
NTERFACE
To create a list name servers:
1.
Click IP Service, DNS.
2.
Select Add Name Server from the Action list.
3.
Enter one name server at a time.
4.
Click Apply.
Figure 17-4: Configuring a List of Name Servers for DNS
To show the list name servers:
1.
Click IP Service, DNS.
2.
Select Show Name Servers from the Action list.
Summary of Contents for SSE-G2252
