Supermicro SSE-G2252, User Manual

Page: 496 / 1401

Chapter 14: Basic Administration Protocols
Connectivity Fault Management
– 503 –
W
EB
I
NTERFACE
To show configuration settings for the fault notification generator:
1.
Click Administration, CFM.
2.
Select Show Information from the Step list.
3.
Select Show Fault Notification Generator from the Action list.
Figure 14-90: Showing Settings for the Fault Notification Generator
D
ISPLAYING
C
ONTINUITY
C
HECK
E
RRORS
Use the Administration > CFM > Show Information (Show Continuity Check
Error) page to display the CFM continuity check errors logged on this
device.
CLI R
EFERENCES
•
“show ethernet cfm errors” on page 1293
•
“clear ethernet cfm errors” on page 1292
P
ARAMETERS
These parameters are displayed:
•
Level – Maintenance level associated with this entry.
•
Primary VLAN – VLAN in which this error occurred.
•
MEP ID – Identifier of remote MEP.
•
Interface – Port at which the error was recorded.
•
Remote MAC – MAC address of remote MEP.
•
Reason – Error types include:
•
LEAK – MA x is associated with a specific VID list
9
, one or more of
the VIDs in this MA can pass through the bridge port, no MEP is
configured facing outward (down) on any bridge port for this MA,
and some other MA y , at a higher maintenance level, and associated
with at least one of the VID(s) also in MA x , does have a MEP
configured on the bridge port.
9. This definition is based on the IEEE 802.1ag standard. Current software for this switch
only supports a single VLAN per MA. However, since it may interact with other devices
which support multiple VLAN assignments per MA, this error message may be
reported.