Chapter 20: System Management Commands
SMTP Alerts
– 698 –
logging sendmail
source-email
This command sets the email address used for the “From” field in alert
messages. Use the
no
form to restore the default value.
S
YNTAX
logging sendmail source-email
email-address
no logging sendmail source-email
email-address
- The source email address used in alert messages.
(Range: 1-41 characters)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
You may use an symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
E
XAMPLE
Console(config)#logging sendmail source-email [email protected]
Console(config)#
show logging
sendmail
This command displays the settings for the SMTP event handler.
C
OMMAND
M
ODE
Normal Exec, Privileged Exec
E
XAMPLE
Console#show logging sendmail
SMTP servers
-----------------------------------------------
192.168.1.19
SMTP Minimum Severity Level: 7
SMTP destination email addresses
-----------------------------------------------
SMTP Source Email Address: [email protected]
SMTP Status: Enabled
Console#
Summary of Contents for SSE-G2252
