Supermicro SSE-G2252, User Manual

Page: 1061 / 1401

Chapter 35: ERPS Commands
– 1074 –
not have an SF condition. This action subsequently unblocks the
traffic channel over the RPL.
e.
A ring node accepting an R-APS (MS) message, without any local
higher priority requests stops transmitting R-APS messages.
f.
A ring node receiving an R-APS (MS) message flushes its FDB.
•
Protection switching on a manual switch request is completed when the
above actions are performed by each ring node. At this point, traffic
flows around the ring are resumed. From this point on, the following
rules apply regarding processing of further manual switch commands:
a.
While an existing manual switch request is present in the ring, any
new manual switch request is rejected. The request is rejected at
the ring node where the new request is issued and a notification is
generated to inform the operator that the new MS request was not
accepted.
b.
A ring node with a local manual switch command which receives an
R-APS (MS) message with a different Node ID clears its manual
switch request and starts transmitting R-APS (NR) messages. The
ring node keeps the ring port blocked due to the previous manual
switch command.
c.
An ring node with a local manual switch command that receives an
R-APS message or a local request of higher priority than R-APS (MS)
clear its manual switch request. The ring node then processes the
new higher priority request.
•
Recovery for manual switching under revertive and non-revertive mode
is described under the Command Usage section for the non-revertive
command.
E
XAMPLE
Console#erps manual-switch domain r&d west
Console#
show erps
This command displays status information for all configured rings, or for a
specified ring
S
YNTAX
show erps [ domain ring-name ] [ statistics ]
domain - Keyword to display ERPS ring configuration settings.
ring-name - Name of a specific ERPS ring. (Range: 1-32 characters)
statistics - Keyword to display ERPS ring statistics.
C
OMMAND
M
ODE
Privileged Exec