Subaru 2006 Legacy, Manual

Page: 807 / 4302

ME(H4SO)-41
Timing Belt
MECHANICAL
7) Remove the belt idler No. 2.
8) Remove the timing belt.
2. BELT IDLER AND AUTOMATIC BELT
TENSION ADJUSTER ASSEMBLY
1) Remove the belt idler (No. 1).
2) Remove the automatic belt tension adjuster as-
sembly.
B: INSTALLATION
1. AUTOMATIC BELT TENSION ADJUST-
ER ASSEMBLY AND BELT IDLER
1) Preparation for installation of automatic belt ten-
sion adjuster assembly.
CAUTION:
• Always use a vertical type pressing tool to
move the adjuster rod down.
• Do not use a lateral type vise.
• Push the adjuster rod vertically.
• Press-in the push adjuster rod gradually tak-
ing more than three minutes.
• Do not allow press pressure to exceed 9, 8 07
N (1,000 kgf, 2,205 lb).
• Press the adjuster rod as far as the end sur-
face of the cylinder. Do not press the adjuster
rod into cylinder. Doing so may damage the cyl-
inder.
• Do not release the press pressure until stop-
per pin is completely inserted.
(1) Attach the automatic belt tension adjuster
assembly to vertical pressing tool.
(2) Slowly move the adjuster rod down with a
pressure of more than 165 N (16.8 kgf, 37.1 lb)
until the adjuster rod is aligned with the stopper
pin hole in the cylinder.
(3) With a 2 mm (0.08 in) dia. stopper pin or a 2
mm (nominal) dia. hex wrench inserted into the
stopper pin hole in cylinder, secure the adjuster
rod.
(A) Belt idler (No. 2)
(B) Belt idler No. 2
ME-02434
(A) (B)
ME-02388
ME-00237
ME-00238
ME-00239
ME-00350
asieps_tobira.book 41 ページ ２００９年１０月２６日 月曜日 午前９時１６分