Subaru 2006 Legacy, Manual

Page: 1356 / 4302

GD(H4SO U5)-130
Diagnostic Trouble Code (DTC) Detecting Criteria
GENERAL DESCRIPTION
Diagnostic method
• The diagnostic method consists of creating a sealed vacuum in the fuel tank and then determining the
presence of leakage from the speed at which the tank internal pressure returns to atmospheric pressure.
• The diagnosis is divided into the following five phases.
Mode A: (Estimated evaporation gas amount)
Calculate the tank pressure change amount (P1) when using mode A. After calculating P1, switch to mode B.
Mode B: (Negative pressure sealed)
Introduce negative pressure in the intake manifold to the tank.
Approximately 0
→
–1.4 kPa (0
→
–10.5 mmHg, 0
→
–0.41 inHg)
When the pressure above (desired negative pressure) is reached, enters Mode C.
In this case, if the tank pressure does not reach the target negative pressure, judge that there is a large leak-
age (10 seconds or 25 seconds) in the system and terminate the evaporative emission control system diag-
nosis.
Abnormality Judgment
Judge as NG (large leak) when the criteria below are met.
Mode C: (Check pressure rise)
Stop the introduction of negative pressure. (Wait until the tank pressure returns to the start level of P2 cal-
culation.)
Change to Mode D when the tank pressure returns to the start level of P2 calculation.
Judge immediate OK and change to Mode E when it does not return in spite of spending the specified time.
Mode D: (Measure amount of negative pressure change)
Monitor the tank pressure change amount when using mode D. In this case, the tank pressure increases,
(nears atmospheric pressure) because evaporation occurs. However, if any leakage exists, the pressure in-
creases additionally in proportion to this leakage. The pressure variation of this tank is P2.
After calculating P2, perform a small leak diagnosis according to the items below.
When Mode D is ended
Assign tank variations measured in Mode A and Mode D; P1 and P2, to the formula below, judge small leaks
in the system. If the measured judgment value exceeds the threshold value, it is judged to be a malfunction.
Abnormality Judgment
Judge as NG when the criteria below are met and judge as OK when not met, and clear NG.
* 1.5: Evaporation amount compensation value when below negative pressure (Amount of evaporation occurrence increases as
a vacuum condition increases.)
Judgment Value
Malfunction Criteria Threshold Value DTC
Time to reach target negative pressure
≥
25 sec. P0457
Or mode B time
≥
10 sec.
(Min. pressure value in tank when in
mode B) – (Tank pressure when mode B
started) < –0.33 kPa
(–2.5 mmHg, –0.097
inHg)
Tank pressure when starting cal-
culation of P2
Time for advanced OK
judgment
–1.3 kPa (–9.75 mmHg, –0.38
inHg) 15 seconds
Judgment Value
Malfunction Criteria Threshold Value DTC
P2 – 1.5 × P1 > Value from Map 7 P0442
P2: Tank pressure that changes every 10
seconds in mode D * Threshold value:
Map (Remaining Fuel
vs Tank temperature)
P1: Tank pressure that changes every 10
seconds in mode A
asieps_tobira.book 130 ページ ２００９年１０月２６日 月曜日 午前９時１６分