Subaru 2006 Legacy, Manual

Page: 2288 / 4302

ME(H4DOTC)-76
Cylinder Block
MECHANICAL
(4) Install the oil pump to cylinder block. Be
careful not to damage the oil seal during instal-
lation.
(5) Apply liquid gasket to the three bolts thread.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
CAUTION:
• Do not forget to install the O-ring and seal
when installing the oil pump.
• Align the flat surface of oil pump’s inner rotor
with crankshaft before installation.
32) Install the water pump and gasket.
Tightening torque:
First: 12 N·m (1.2 kgf-m, 8.9 ft-lb)
Second: 12 N·m (1.2 kgf-m, 8.9 ft-lb)
CAUTION:
• Be sure to use a new gasket.
• When installing the water pump, tighten bolts
in two stages in alphabetical sequence, as
shown in the figure.
33) Install the water by-pass pipe for heater.
34) Install the oil cooler.
Tightening torque:
T1: 54 N·m (5.5 kgf-m, 40 ft-lb)
T2: 70 N·m (7.1 kgf-m, 50.6 ft-lb)
35) Install the oil filter. <Ref. to LU(H4DOTC)-24,
INSTALLATION, Engine Oil Filter.>
36) Install the water by-pass pipe between oil cool-
er and water pump.
37) Install the water pipe.
NOTE:
Always use new O-rings.
38) Install the cylinder head.
<Ref. to ME(H4DOTC)-57, INSTALLATION, Cylin-
der Head.>
39) Install the oil level gauge guide. (LH side)
40) Install the rocker cover and rocker cover gas-
ket.
NOTE:
Use a new rocker cover gasket.
41) Install the crank sprocket. <Ref. to
ME(H4DOTC)-51, INSTALLATION, Crank Sprock-
et.>
LU-02103
T
ME-02463
(F)
(E)
(D)
(C)
(B)
(A)
(A) O-ring
(B) Oil cooler
(C) Oil cooler connector
ME-00723
T2
(C)
(B)
(A)
T1
asieps_tobira.book 76 ページ ２００９年１０月２６日 月曜日 午前９時１６分