Subaru 2006 Legacy, Manual

Page: 2281 / 4302

ME(H4DOTC)-69
Cylinder Block
MECHANICAL
B: INSTALLATION
1) Remove oil on the mating surface of bearing and
cylinder block before installation. Apply engine oil
to crankshaft pins.
2) Position the crankshaft and O-rings on the #1
and #3 cylinder block.
3) Apply liquid gasket to the mating surface of #1
and #3 cylinder blocks, and position cylinder block
#2 and #4.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
NOTE:
Do not allow liquid gasket to run over to O-ring
grooves, oil passages, bearing grooves, etc.
4) Apply a coat of engine oil to the washer and bolt
thread.
5) Tighten the 10 mm cylinder block connecting
bolts on LH side (A — D) in alphabetical sequence.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
(1) Crankshaft bearing (3) Cylinder block (5) O-ring
(2) Crankshaft (4) Rear oil seal
ME-02780
(4)
(1)
(3)
(3)
(2)
(5)
ME-00145
ME-00779
(A)
(B)
(D)
(C)
asieps_tobira.book 69 ページ ２００９年１０月２６日 月曜日 午前９時１６分