Subaru 2006 Legacy, Manual

Page: 254 / 4302

EN(H4SO)(diag)-217
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step Check Yes No
1 CHECK ANY OTHER DTC ON DISPLAY.
Is any other DTC displayed? Check the appro-
priate DTC using
the “List of Diag-
nostic Trouble
Code (DTC)”.
<Ref. to
EN(H4SO)(diag)-
70, List of Diag-
nostic Trouble
Code (DTC).> Go to step
2
.
2 CHECK FUEL FILLER CAP.
1) Turn the ignition switch to OFF.
2) Check the fuel filler cap.
NOTE:
The DTC is stored in memory if fuel filler cap is
or was loose or if the cap chain was caught
while tightening.
Is the fuel filler cap tightened
securely? Go to step 3 . Securely install the
fuel filler cap.
3 CHECK FUEL FILLER CAP.
Is the fuel filler cap genuine? Go to step
4
. Replace with a
genuine fuel filler
cap.
4 CHECK FUEL FILLER PIPE PACKING.
Is there any damage to the
seal between fuel filler cap and
fuel filler pipe? Repair or replace
the fuel filler cap
and fuel filler pipe.
<Ref. to
FU(H4SO)-47,
Fuel Filler Pipe.> Go to step
5
.
5 CHECK DRAIN VALVE.
1) Connect the test mode connector.
2) Turn the ignition switch to ON.
3) Check the drain valve.
NOTE:
Drain valve operation can be executed using
Subaru Select Monitor. For procedure, refer to
“Compulsory Valve Operation Check Mode”.
<Ref. to EN(H4SO)(diag)-44, Compulsory
Valve Operation Check Mode.>
Does the drain valve operate? Go to step 6 . Replace the drain
valve. <Ref. to
EC(H4SO)-15,
Drain Valve.>
6 CHECK PURGE CONTROL SOLENOID
VALVE.
Operate the purge control solenoid valve.
NOTE:
Purge control solenoid valve operation can be
executed using Subaru Select Monitor. For pro-
cedure, refer to “Compulsory Valve Operation
Check Mode”. <Ref. to EN(H4SO)(diag)-44,
Compulsory Valve Operation Check Mode.>
Does the purge control sole-
noid valve operate? Go to step 7 . Replace the purge
control solenoid
valve. <Ref. to
EC(H4SO)-6,
Purge Control
Solenoid Valve.>
7 CHECK PRESSURE CONTROL SOLENOID
VALVE.
Operate the pressure control solenoid valve.
NOTE:
The pressure control solenoid valve operation
can be executed using the Subaru Select Mon-
itor. For procedure, refer to “Compulsory Valve
Operation Check Mode”.
<Ref. to EN(H4SO)(diag)-44, Compulsory
Valve Operation Check Mode.>
Does the pressure control
solenoid valve operate? Go to step
8
. Replace the pres-
sure control sole-
noid valve. <Ref.
to EC(H4SO)-6,
Purge Control
Solenoid Valve.>
asieps_tobira.book 217 ページ ２００９年１０月２６日 月曜日 午前９時１６分