Subaru 2006 Legacy, Manual

Page: 3720 / 4302

5MT-31
Oil Seal
MANUAL TRANSMISSION AND DIFFERENTIAL
5. Oil Seal
A: INSPECTION
Check for leakage of gear oil from the oil seal. If
there is oil leakage, replace with a new oil seal.
B: REPLACEMENT
1) Clean the transmission exterior.
2) Drain gear oil completely.
NOTE:
• Tighten the drain plug of the transmission gear
oil after draining the gear oil.
• Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 33 ft-lb) (Aluminum gas-
ket)
70 N·m (7.1 kgf-m, 51 ft-lb) (Copper gasket)
3) Remove the rear exhaust pipe and muffler.
<Ref. to EX(H4SO)-8, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H4SO)-10, REMOVAL, Muf-
fler.>
4) Remove the heat shield cover. (If equipped)
5) Remove the propeller shaft. <Ref. to DS-10, RE-
MOVAL, Propeller Shaft.>
6) Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
7) Using the ST, install the oil seal.
ST 498057300 INSTALLER
8) Install the propeller shaft. <Ref. to DS-11, IN-
STALLATION, Propeller Shaft.>
9) Install the heat shield cover. (If equipped)
10) Install the rear exhaust pipe and muffler. <Ref.
to EX(H4SO)-8, INSTALLATION, Rear Exhaust
Pipe.> <Ref. to EX(H4SO)-10, INSTALLATION,
Muffler.>
11) Pour in gear oil and check the oil level. <Ref. to
5MT-23, REPLACEMENT, Transmission Gear
Oil.>
(A) Oil seal
MT-00097
MT-00098
(A)
ST
MT-00099
asieps_tobira.book 31 ページ ２００９年１０月２６日 月曜日 午前９時１６分