Subaru 2006 Legacy, Manual

Page: 3904 / 4302

DI-3 8
Rear Differential (T-type)
DIFFERENTIALS
13) Install the hypoid driven gear to differential
case.
NOTE:
• Before installing bolts, apply seal material to bolt
threads.
SEAL MATERIAL
THREE BOND 1324 (Part No. 004403042)
• Tighten diagonally while tapping the bolt heads.
Tightening torque:
103 N·m (10.5 kgf-m, 76 ft-lb)
14) Press the side bearing into differential case us-
ing ST.
ST 398487700 DRIFT
15) Press-fit the side bearing cone to the side bear-
ing retainer using the ST.
ST 398177700 DRIFT
16) Adjusting the side bearing retainer shims
(1) The hypoid driven gear backlash and side
bearing preload can be adjusted by the side
bearing retainer shim thickness.
(2) Install the differential assembly into differen-
tial carrier in the reverse order of disassembly.
(3) Install the side bearing retainer shims to re-
tainers RH and LH from which they were in-
stalled.
NOTE:
Replace broken or corroded side retainer shims
with a new part of the same thickness.
(4) Align the arrow mark on differential carrier
with the mark on side retainer during installa-
tion.
NOTE:
Be careful that side bearing outer race is not dam-
aged by the bearing roller.
(5) Tighten the side bearing retainer bolts.
Tightening torque:
10.5 N·m (1.1 kgf-m, 7.7 ft-lb)
DI-00068
ST
DI-00095
DI-00065
Side bearing retainer shim
Part No. Thickness mm (in)
383475201 0.20 (0.0079)
383475202 0.25 (0.0098)
383475203 0.30 (0.0118)
383475204 0.40 (0.0157)
383475205 0.50 (0.0197)
(A) Arrow mark
(A)
DI-00097
DI-00098
asieps_tobira.book 38 ページ ２００９年１０月２６日 月曜日 午前９時１６分