Subaru 2006 Legacy, Manual

Page: 1878 / 4302

FU(H4DOTC)-37
Exhaust Temperature Sensor
FUEL INJECTION (FUEL SYSTEMS)
19.Exhaust Temperature Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the joint pipe.
<Ref. to EX(H4DOTC)-11, REMOVAL, Joint Pipe.>
3) Apply spray type lubricant to the threaded por-
tion of exhaust temperature sensor, and leave it for
one minute or more.
4) Remove the exhaust temperature sensor.
CAUTION:
When removing the exhaust temperature sen-
sor, wait until exhaust pipe cools, otherwise it
may damage the exhaust pipe.
B: INSTALLATION
1) Before installing exhaust temperature sensor,
apply anti-seize compound only to the threaded
portion of exhaust temperature sensor. This facili-
tates the next removal.
CAUTION:
Never apply anti-seize compound to protector
of the exhaust temperature sensor.
Anti-seize compound:
NEVER-SEEZ NS-165 or the equivalent
2) Install the exhaust temperature sensor.
NOTE:
Align the harness (A) of exhaust temperature sen-
sor to the marking (B) of joint pipe, and tighten the
screws.
Tightening torque:
21 N·m (2.1 kgf-m, 15.2 ft-lb)
3) Install the joint pipe.
<Ref. to EX(H4DOTC)-11, INSTALLATION, Joint
Pipe.>
4) Connect the battery ground cable to the battery.
IN-00203
FU-00372
FU-01018
(A)
(B)
IN-00203
asieps_tobira.book 37 ページ ２００９年１０月２６日 月曜日 午前９時１６分