Subaru 2006 Legacy, Manual

Page: 50 / 4302

PI-12
Pre-delivery Inspection
PRE-DELIVERY INSPECTION
4) Press the “UNLOCK” button momentarily on the
keyless transmitter. When the door of the driver’s
seat is unlocked, the buzzer sounds twice, the haz-
ard light flashes twice, the room light turns on and
the security indicator light flashes once in three
seconds, and the alarm system enters the release
mode.
5) Close all the doors including rear gate. Press the
“LOCK” button momentarily on the keyless trans-
mitter. When all the doors are locked, buzzer
sounds once, hazard blinks once and the alarm
system is in set condition in 30 seconds.
6) Unlock a door using the inner lock knob and
open the door while the security system is in the set
mode. Check if the alarm condition happens (horn
sounds continuously, hazard light blinks, security
indicator comes on). Check if this condition lasts for
a maximum of three minutes or until the “UNLOCK”
button of the keyless transmitter is pressed.
NOTE:
The alarm condition will cease in 30 seconds once
the door is closed.
7) When none of above is applicable, check the
troubleshooting of security system.
24.SEATS
1) Check the seat surfaces for stains or dirt.
2) Check that each seat provides full functionality in
sliding and reclining. Check all available functions
of the rear seat such as a trunk-through center arm-
rest.
3) Check the passenger’s seat occupant detection
system.
(1) Turn the ignition switch to ON.
(2) Check that the ON and OFF of passenger’s
airbag indicator light come on simultaneously
for about 6 seconds and go off for 2 seconds,
and then only OFF comes on again.
(3) With a person weighing approximately 70 kg
(155 lb) or more sitting in the passenger’s seat,
check whether the passenger’s airbag indicator
light illuminates or not.
(4) Empty the passenger seat, then check
whether the passenger side airbag indicator
light turns off.
25.SEAT BELT
1) Check installation condition of seat belt.
2) Pull out the seat belt and then release it. Check
that the belt retracts smoothly.
3) Check seat belt warning system
(1) Turn the ignition switch to ON without fas-
tening driver’s and passenger’s seat belts.
(2) Check if the seat belt warning lights of driv-
er’s and passenger’s side blink for about six
seconds and the buzzer beeps intermittently.
(3) Then, check that the seat belt warning light
comes on
→
blink
→
buzzer beeps in about 15
seconds cycles. (If the passengers seat is emp-
ty, seat belt warning light for passengers side
does not operate.)
PI-00256
OD-00036
asieps_tobira.book 12 ページ ２００９年１０月２６日 月曜日 午前９時１６分