Subaru 2006 Legacy, Manual

Page: 3276 / 4302

4AT-123
Transmission Control Device
AUTOMATIC TRANSMISSION
2) Insert the select lever, and then tighten the bolt.
Tightening torque:
6 N·m (0.6 kgf-m, 4.3 ft-lb)
3) Insert the manual plate and parking rod.
4) Insert a new straight pin to manual plate.
5) Install the oil pan and the control valve assem-
bly. <Ref. to 4AT-58, INSTALLATION, Control
Valve Body.>
6) Turn over the transmission case to its original
position.
7) Install the pitching stopper bracket.
Tightening torque:
41 N·m (4.2 kgf-m, 30.4 ft-lb)
8) Install and adjust the inhibitor switch. <Ref. to
4AT-46, Inhibitor Switch.>
9) Insert the inhibitor switch and transmission con-
nector to the stay.
10) Install the air breather hose. <Ref. to 4AT-66,
INSTALLATION, Air Breather Hose.>
11) Insert the input shaft while rotating it lightly by
hand, and then check the amount of protrusion.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
12) Install the torque converter assembly. <Ref. to
4AT-68, INSTALLATION, Torque Converter As-
sembly.>
13) Install the transmission assembly to the vehi-
cle. <Ref. to 4AT-38, INSTALLATION, Automatic
Transmission Assembly.>
C: INSPECTION
Make sure that the manual lever and detention
spring are not worn or otherwise damaged.
(A) Bolt
(B) Range select lever
(C) Manual plate
(D) Parking rod
AT-00308
AT-02225
(A)
(B)
(C)
(D)
AT-02224
(A) Transmission connector
(B) Inhibitor switch connector
AT-01351
(B)
(A)
AT-00291
A
asieps_tobira.book 123 ページ ２００９年１０月２６日 月曜日 午前９時１６分