Subaru 2006 Legacy, Manual

Page: 3087 / 4302

ME(H6DO)-64
Cylinder Block
MECHANICAL
B: INSTALLATION
1) After setting the cylinder block to ST, install the
crankshaft bearing.
ST 18232AA000 ENGINE STAND
NOTE:
Remove oil on the mating surface of bearing and
cylinder block before installation. Apply a coat of
engine oil to crankshaft pins.
2) Position the crankshaft and connecting rod on
#2, #4 and #6 cylinder block.
3) Apply liquid gasket to the mating surface of the
#1, #3 and #5 cylinder blocks, and position it on #2,
#4 and #6 cylinder blocks.
Liquid gasket:
Three bond 1215B (Part No. 004403007)
NOTE:
Do not allow liquid gasket to run over to oil passag-
es, bearing grooves, etc.
Applying liquid gasket diameter:
1.0
±
0.2 mm (0.039
±
0.008 in)
4) Apply a coat of engine oil to the washer and bolt
thread.
5) Tighten all bolts in the numerical order as shown
in the figure.
Tightening torque:
(1) — (11), (13): 25 N·m (2.5 kgf-m, 18 ft-lb)
(12), (14): 20 N·m (2.0 kgf-m, 14 ft-lb)
6) Retighten all bolts in the numerical order as
shown in the figure.
Tightening torque:
(1) — (11), (13): 25 N·m (2.5 kgf-m, 18.4 ft-lb)
(12), (14): 20 N·m (2.0 kgf-m, 14 ft-lb)
7) Tighten all bolts 90° — 110° in the numerical or-
der as shown in the figure.
8) Install the upper bolt to cylinder block.
Tightening torque:
25 N·m (2.5 kgf-m, 18 ft-lb)
NOTE:
Remove the liquid gasket which is running over to
sealing surface between cylinder block and rear
chain cover, cylinder block and oil pan upper, after
tightening the bolts which combine the cylinder
block.
ME-00567
(1) (6) (8) (3) (9)
(2) (4) (5) (7) (10)
(11)
(12)
(13)
(14)
ME-00568
(1) (6) (8) (3) (9)
(2) (4) (5) (7) (10)
(11)
(12)
(13)
(14)
ME-00568
(1) (6) (8) (3) (9)
(2) (4) (5) (7) (10)
(11)
(12)
(13)
(14)
ME-00568
ME-00569
asieps_tobira.book 64 ページ ２００９年１０月２６日 月曜日 午前９時１６分